Blog

Causes of low-voltage insulator failures

Aug 02, 2026 Leave a message

Insulator failures fall into two categories: flashover and puncture. Flashover occurs on the insulator surface, leaving visible burn marks, yet the insulator typically retains some insulating capability. Puncture occurs internally, with a discharge passing through the porcelain body between the metal cap and the pin; while the exterior may show no signs of damage, the insulator loses its insulating properties entirely, and the resulting electric arc can cause complete destruction of the unit. Research indicates that for 10 kV overhead distribution lines, the primary cause of lightning-induced flashovers or failures is not overvoltage from direct lightning strikes, but rather overvoltage from induced lightning. The probability of a distribution line experiencing direct lightning overvoltage is low-accounting for approximately 20% of lightning-related incidents-whereas induced lightning overvoltage is responsible for about 80% of such failures.

 

Induced overvoltages across the three phases of the line are essentially identical. The induced lightning wave propagates rapidly along the line in both directions from the pole or tower, reaching points of insulation weakness near the insulators and discharging toward the crossarm, thereby causing a lightning flashover. When induced overvoltage triggers simultaneous flashover across two or three phases, an arc may establish itself along the flashover path, leading to a power-frequency follow current and a short-circuit arc with a magnitude of several thousand amperes. A prolonged power-frequency follow current can cause the line to trip due to a short circuit, or result in porcelain insulator explosion and conductor breakage, leading to safety incidents. Even if the flashover duration is brief and the line trips, burn marks may remain on the insulator surface, increasing leakage current. The foregoing analysis demonstrates that reducing line trips requires the installation of protective devices designed to: minimize the frequency of lightning strikes on the line; facilitate discharge after a strike but before the lightning wave punctures the insulation; and rapidly restore insulation integrity following the discharge.

Send Inquiry